Call (559) 388-2155 · Mon–Sun 8am–8pm
Serving Fresno · Clovis · Madera · Selma · Reedley · Hanford
Home > PAINT CORRECTION
PAINT CORRECTION in Fresno, CA
Machine polishing that removes swirls, light scratches, oxidation, and water spots from your clear coat. We measure paint depth with a gauge before we cut. Honest scope: if we cannot fix it, we say so.
Takes about a minute · Same-week slots go first
Since 2015
11 years in Fresno
4.9 / 210
Google reviews
Mobile-first
Vans carry own water + power
Prices published
Details from $179
paint correction IN FRESNO: One-Step vs Two-Step
Every coating starts with a free paint inspection. We measure, we look closely, and we tell you what your paint actually needs before recommending a tier. Warranty terms come in writing before you pay.
one step polish
$50 to $300
A single polishing stage that removes light swirls and restores gloss. Right for paint that is dull but not deeply damaged. Most daily drivers land here.
Takes 2-4 hours
Two Step correction
$600 to $1,200
Compounding followed by refining polish. Removes deeper defects, oxidation, and heavier swirl patterns. For paint that needs real rescue.
Takes 8-14 hours
MIDDLE OPTION
$300 to $600
The free inspection decides which level your paint needs. We will never sell you two steps when one will do.
Takes 4 to 7 hours
What PAINT CORRECTION FIXES
Swirl mark removal. That spiderwebbing you see in direct sun comes from tunnel washes and dirty towels. We polish it out properly.
Light scratches that have not gone through the clear coat.
Oxidation. That chalky, faded look Valley sun bakes into neglected paint.
Water spots and etching from Fresno hard water.
Holograms and buffer trails from a bad previous detail.
What IT CANNOT FIX
Fingernail-deep scratches are beyond correction. Rock chips that went through to primer need touch-up paint, not polishing. We check with a gauge and tell you plainly which defects are correctable and which are not, before you spend a dollar.
OUR PROCESS
01
Wash and decontaminate. You cannot correct dirty paint.
02
Paint-depth measurement, panel by panel, with a gauge. Thin paint does not get cut. Period.
03
Test spot. Because every paint system cuts differently, with German clear coats running hard and Japanese systems staying soft, we always prove the pad and compound combination on one section before committing to the whole car. You approve the result first.
04
Machine polishing: dual-action polishers, the right pad and compound for your paint.
05
Panel wipe and final inspection in proper lighting. You see the before and after side by side.
Proof of work
See the Transformation
BEFORE
AFTER
Interior detail: before and after.
WHY BOOK WITH US
Published prices
Honest scope. If a scratch is too deep, we say so instead of charging you to try.
Named products
Correction is all we do here some weeks. It is a specialty, not an upsell.
TEST SPOT FIRST
You approve the result before we touch the whole car. Paint gauge before cutting. Most shops skip this. We never do.
Proven in Fresno
Since 2015, and our corrections hold up because the prep is real.
Reviews
What Fresno Drivers Say
Where We Go
Service Areas
We run mobile routes across Fresno, Clovis, Madera, Selma, Reedley, and Hanford, and all of the Central Valley.
Travel beyond 15 miles from our Fresno shop adds a flat $30 trip fee.
Fresno
Clovis
Madera
Selma
Reedley
Hanford
Outside these six cities? We cover all of the Central Valley. Call (559) 388-2155 for a trip quote.
ceramic coating FAQ
What is paint correction?
Machine polishing that permanently removes defects from your clear coat: swirls, light scratches, oxidation, water spots. It is not a wax and not a filler. Fillers hide defects for a few washes; correction actually levels the paint.
How much does paint correction cost?
One-step polish runs $50 to $300 and takes 2 to 4 hours. The middle enhancement option runs $300 to $600 and takes 4 to 7 hours. Two-step correction runs $600 to $1,200 and takes 8 to 14 hours. The free inspection decides which your paint needs, and the quote is fixed before we start.
How long does paint correction take?
One-step: 2 to 4 hours, done in a day. Middle option: 4 to 7 hours. Two-step: 8 to 14 hours, usually across two days. We give you the exact timeline at the free inspection so you can plan around it.
Can paint correction remove deep scratches?
If your fingernail catches in it, probably not. Correction works within the clear coat; scratches through to primer or metal need touch-up paint or a body shop. We test every deep scratch at inspection and tell you honestly.
What is the difference between paint correction and polishing?
Polishing is the tool; paint correction is the measured process. Anyone can run a polisher over a car. Correction means measuring paint depth, choosing the right cut, proving it on a test spot, and refining the finish. One is motion, the other is method.
Should I get ceramic coating after paint correction?
Not required, but it is the smartest next step. Correction is the mandatory prep for coating anyway, so many customers do both while the paint is already perfect. Ask us at the inspection and we will price the bundle.
RELATED SERVICES
car detailing Fresno
Pair it with a fresh start
CERAMIC COATING Fresno
Long-term paint protection that lasts years, not weeks.
Mobile Detailing Fresno
The full shop experience, delivered to your driveway.
Coat It Before Summer Does Its Worst?
Takes about a minute · Same-week slots go first
Fresno's mobile auto detailing specialists since 2015. We bring the shop to your driveway across Fresno County and the Central Valley.
Highway 99 Detailing LLC
4762 W Jennifer Ave Suite 108, Fresno, CA 93722
Mon–Sun · 8:00 AM – 8:00 PM
Areas: Fresno · Clovis · Madera · Selma · Reedley · Hanford · Central Valley
© 2026 Highway 99 Detailing LLC